Hello!
I’m a beginner of Pylith. I want to know if it’s possible to simulate dynamic rupture in Pylith-4.2. I couldn’t find FaultCohesiveDyn in version 4.2, which was available in version 2.2.2.
Any replies and suggestions will be valuable to me.
Spontaneous rupture (fault friction) is not yet ported to the multi-physics formulation used in PyLith v3 and after. This feature is under active development.
Thank you！ I successfully installed Pylith-4.2, but I failed to install v2.2.2. I will continue to try to install v2.2.2. Thank you for your reply again.